Contact Us

Products

Home  ꀇ  Aluminum Solar Road Stud  ꀇ  Synchronous Embedded Solar Road Stud G #

Synchronous Embedded Solar Road Stud G #

Item No.: 
RSAS-2-IN-G Two-way
RSAS-1-IN-G One-way

Characteristics: 
Wireless synchronous flash, visible under streetlight,snow plow-proof

Key Features:
For pedestrian crossing, center line, slip road and other heavy traffic use,
Only 6.5 mm above the road surface,
40 tons compression resistance,
500 m visible,
    • Size
      φ126*56.5mm
    • Net Weight
      1.02kg
    • Material
      Aluminum alloy shell+Polycarbonate+epoxy filler
    • LED
      φ5mm, one-way 3pcs, two-way 6pcs
    • LED Working Mode
      Flash (2HZ or upon request)
    • Luminous intensity
      5000mcd
    • View distance
      over 500m
    • Color
      Red/Yellow/White/Blue/Green
    • Solar Panel
      Monocrystalline silicon 5V 120MA
    • Battery
      Anti-heat Li battery /3.2V 1000MAH
    • Battery Life span
      More than 3 years
    • Charge time
      8 hours @100 Klux(sunny day)
    • Working time
      72 hours
    • Synchronous Mode
      G# satellite's signal calibration
    • Activation
      photo sensor
    • Starting intensity
      500Lux
    • Compression resistance
      over 40 tons
    • Working temperature
      -20℃～+70℃
    • Ingress Protection
      IP68
    • Warranty
      One year

  • Installation:
    1.Preparation: Wear correct personal protection equipment and lay the work zone safety equipment properly.
    2.Confirm the installation position. Make sure the road surface is flat.
    3.Clean the road surface and make sure the road surface is dry. 
    4.Drill a hole with a diameter 128 mm depth 62 mm with the core drill. 
    5.Use air pick to remove the bitumen inside the hole. Remove all debris in the hole and make sure the bottom is flat. 
    6.Wait till the hole is dry.Spread some epoxy glue all over the hole and insert the road stud. 
    7.Make sure the LEDs face the direction of traffic. 
    8.Press the road stud to make it firmly installed, leaving the four wings mounted on the road surface.
    9.Remove the spilt glue. 
    10.Two hours after the installation, go and check all solar road studs to make sure they  are installed in right direction and horizontal to the road surface.
    11.Take away the work zone safety equipment after two hours.

    Application:
    • Road Delineation
    • Accident black-spots / cluster sites
    • Hazardous road layouts
    • Areas adversely affected by poor visibility
    • Cycle path 
    • Car parks 
    • Before speed hump

    Carton:
    62*34.5*16.5cm GW:1110g/pc NW: 1020g/pc   20pcs/carton

  • Item No.: 
    RSAS-2-IN-G Two-way
    RSAS-1-IN-G One-way

    Characteristics: 
    Wireless synchronous flash, visible under streetlight,snow plow-proof

    Key Features:
    For pedestrian crossing, center line, slip road and other heavy traffic use,
    Only 6.5 mm above the road surface,
    40 tons compression resistance,
    500 m visible,
끸
Verification code
Submit

Related Products