Embedded Aluminum Solar Road Stud

Item No.:
RSAS-F2-IN （two way）-F(Flash) -S(Steady)
RSAS-F1-IN （one way）-F(Flash) -S(Steady)

Key Features:
For centre line, slip road and other heavy traffic use
Only 6.5mm above the road surface
40 tons compression resistance
500m visible

Spot lighting:
flexible solar panel
aluminium alloy+Polycarbonate+epoxy filler
Ø126*H56.5mm
1.02kg
red blue green yellow white
IP 68

- Size
  
  φ126*56.5mm
- Net Weight
  
  1.02kg
- Material
  
  Aluminum alloy shell+Polycarbonate+epoxy filler
- LED
  
  φ5mm, one-way 3pcs, two-way 6pcs
- LED Working Mode
  
  Steady or Flash (2HZ or upon request)
- Luminous intensity
  
  5000mcd
- View distance
  
  over 500m
- Color
  
  Red/Yellow/White/Blue/Green
- Solar Panel
  
  Flexible solar panel 5V 80MA
- Battery
  
  Anti-heat Li battery /3.2V 1000MAH
- Battery Life span
  
  More than 3 years
- Charge time
  
  8 hours @100 Klux(sunny day)
- Working time
  
  72 hours
- Activation
  
  photo sensor
- Starting intensity
  
  500Lux
- Compression resistance
  
  over 40 tons
- Working temperature
  
  -20℃～+70℃
- Ingress Protection
  
  IP68
- Warranty
  
  One year
Installation:
1.Preparation. Wear correct personal protection equipment and lay the work zone safety equipment properly.
2.Confirm the installation position. Make sure the road surface is flat.
3.Clean the road surface and make sure the road surface is dry.
4.Drill a hole with a diameter128mm depth62mm with the core drill.
5.Use air pick to remove the bitumen inside the hole. Remove all debris in the hole and make sure the bottom is flat.
6.Wait till the hole is dry.Spread some epoxy glue all over the hole and insert the road stud.
7.Make sure the LEDs face the direction of traffic.
8.Press the road stud to make it firmly installed, leaving the four wings mounted on the road surface.
9.Remove the spilt glue.
10.Two hours after the installation, go and check all solar road studs to make sure they are installed in right direction and horizontal to the road surface.
11.Take away the work zone safety equipment after two hours.

Application:
• Road Delineation
• Accident black-spots / cluster sites
• Hazardous road layouts
• Areas adversely affected by poor visibility
• Cycle path
• Car parks
• Before speed hump

Carton:
62*34.5*16.5cm GW: 1110g/pc NW: 1020g/pc 20pcs/carton
Item No.:
RSAS-F2-IN （two way）-F(Flash) -S(Steady)
RSAS-F1-IN （one way）-F(Flash) -S(Steady)

Key Features:
For centre line, slip road and other heavy traffic use
Only 6.5mm above the road surface
40 tons compression resistance
500m visible

Spot lighting:
flexible solar panel
aluminium alloy+Polycarbonate+epoxy filler
Ø126*H56.5mm
1.02kg
red blue green yellow white
IP 68